Path protection
| Purpose | To protect against inevitable failures on service providers’ network that might affect the services offered to end customers |
|---|---|
| RFC(s) | 3031 |
Path protection in telecommunications is an end-to-end protection scheme used in connection oriented circuits in different network architectures to protect against inevitable failures on service providers’ network that might affect the services offered to end customers. Any failure occurred at any point along the path of a circuit will cause the end nodes to move/pick the traffic to/from a new route.
Other techniques to protect telecommunications networks against failures are: Channel Protection, Link Protection, Segment-Protection, and P-cycle Protection
In ring-based networks topology where the setup is to form a closed loop among the Add Drop Multiplexers, there is basically one path related ring protection scheme available in Unidirectional Path-Switched Ring architecture. In SDH networks, the equivalent of UPSR is Sub-Network Connection Protection (SNCP). Note that SNCP does not assume a ring topology, and can also be used in mesh topologies.
In UPSR, the data is transmitted in both directions, clock and counter clock wise, at the source ADM. At the destination then, both signals are compared and the best one of the two is selected. If a failure occurs then the destination just needs to switch to the unaffected path.
Circuits in optical mesh networks can be unprotected, protected to a single failure, and protected to multiple failures. The end optical switches in protected circuits are in charge of detecting the failure, in some cases requesting digital cross connects or optical cross-connects in intermediate devices, and switching the traffic to/from the backup path. When the primary and backup paths are calculated, it is important that they are at least link diverse so that a single link failure does not affect both of them at the same time. They can also be node diverse, which offers more protection in case a node failure occurs; depending on the network sometimes the primary and backup path cannot be provisioned to be node diverse at the edges, ingress and egress, node.
...
Wikipedia